One-Rep Max Calculator
Seven formulae compared, plus the loads for every rep range.
Why there are seven formulae and no single right one
Every 1RM equation is a curve fitted to observed data from a particular group of lifters performing a particular set of lifts. They agree closely around five to eight reps and diverge sharply as the rep count climbs, because the underlying relationship between load and reps is not linear and different studies sampled different populations. At ten reps the spread between formulae is typically five to ten percent; at twenty reps it can exceed twenty percent. That divergence is a property of the extrapolation, not an error in any single equation.
The formulae used
- Epley:
w × (1 + reps ÷ 30)— the most widely used, reasonably accurate to about ten reps. - Brzycki:
w × 36 ÷ (37 − reps)— tends to be conservative at higher rep counts. - Lander:
100w ÷ (101.3 − 2.67123 × reps)— fitted from competitive powerlifters. - Lombardi:
w × reps^0.10— simple, and it overestimates badly above ten reps. - Wathen:
100w ÷ (48.8 + 53.8 × e^(−0.075 × reps))— an exponential fit rather than a linear one. - Mayhew and O'Conner: two further variants fitted to different athlete groups.
The reps-in-reserve correction
Repetitions in reserve is the honest variable most calculators ignore. If you lifted 100 kg for five reps and could have done two more, that set was really a seven-rep-max effort, and using five in the formula underestimates your 1RM substantially. This tool adds the reserve to the rep count before applying the formulae. Estimating RIR accurately is a skill in itself — most people underestimate it at high rep counts, where the discomfort of the final reps makes a genuine failure point hard to judge.
Accuracy falls off with rep count
Prediction error grows the further you extrapolate. Estimates from two to five reps are generally reliable to within a few percent; beyond ten reps the error widens and the formulae disagree with each other by enough to matter. This matters practically: if you want to know your true 1RM, testing it — or testing a heavy triple — is more accurate than inferring it from a set of fifteen. Testing a true 1RM is a demanding effort that requires appropriate preparation and, for free-weight barbell lifts, competent spotting.
Why the percentage table is the actually useful output
Programming is mostly about selecting loads for target rep ranges, and working backwards from an estimated 1RM to a percentage is how that is written. The table here applies the Epley relationship in reverse. Treat it as a starting point: individual variation in rep capacity at a given percentage is large, and the same percentage will feel very different on a squat versus a curl, partly because of the muscle mass involved and partly because of the range of motion.
Cautions
- Estimates are for the specific lift and the form you used — a 1RM derived from a partial range of motion does not transfer to a full one.
- Fatigue, sleep and training age all shift the number day to day.
- Nothing here accounts for injury history or the safety of attempting a maximal lift unassisted.